Iphone 6 wifi anten

     

Opening the display on the 6s Plus separates a thin strip of adhesive around the perimeter of the display. If you prefer to replace the adhesive, have a set of new adhesive strips ready before you continue. It"s possible to lớn complete the repair without replacing the adhesive, & you probably won"t notice any difference in functionality.

Bạn đang xem: Iphone 6 wifi anten





Pull up on the suction cup with firm, constant pressure lớn create a slight gap between the front panel & rear case.


*
*


Use a plastic opening tool khổng lồ hold down the rear case while pulling up the suction cup to xuất hiện the phone.


Gently grasp the display assembly and lift it up to open the phone, using the clips at the vị trí cao nhất of the front panel as a hinge.


Open the display to about a 90º angle, & lean it against something khổng lồ keep it propped up while you"re working on the phone.


Don"t xuất hiện the display more than 90º—it is still connected to the đứng top of the phone by the display, digitizer, và front camera cables which can tear easily.


Add a rubber band to keep the display securely in place while you work. This prevents undue strain on the display cables.

Xem thêm: Please Wait - Cách Cập Nhật Hệ Điều Hành Cho Thiết Bị Android


Remove two Phillips screws securing the battery connector bracket to lớn the ngắn gọn xúc tích board, of the following lengths:


Use a plastic opening tool lớn disconnect the digitizer cable by prying it straight up from its socket on the xúc tích và ngắn gọn board.


Use the pointed tip of a spudger khổng lồ gently pry the cellular antenna cable from the middle xúc tích board clip.


Tip the lô ghích board up to a vertical position lớn expose the single antenna connector on the underside, near the top edge of the board.


Gently lay the logic board upside-down, with the vị trí cao nhất portion resting against the rear case of the iPhone.


Give the author +30 points! You're Finished!

Cancel: I did not complete this guide.

29 other people completed this guide.


Didn"t you forget to mention first step khổng lồ remove the two little screws by the nguồn connector? First time doing this và I ended up breaking the metal threaded tabs that the screws go into :(

I guess I should have realized it would have screws somewhere & also researched some more before attempting the repair.

Oh well, looks lượt thích I will need to get some teflon tape or something lớn hold things together.